|
ATPL 10 AIR LAW AND ATC PROCEDURES |
| 10.05 - ICAI Annex 2: Rules of the air |
|
1
In a standard holding pattern turns are made :
To the right |
|
2
Related to the three entry sectors in a holding pattern, there is a zone of flexibility on either side of the sectors boundaries of:
5° . |
|
3
How far beyond the boundary of the holding area extends the buffer area?
5 nm. |
|
4
In relation to the three entry sectors, the entry into the holding pattern shall be according to:
Heading. |
|
5
Standard airway holding pattern below 14 000 ft ?
Right hand turns / 1 minute outbound |
|
6
You have received holding instructions for a radio fix. the published holding procedure is: all turns to the right, 1 minute outbound, inbound mc 052° . you are approaching the fix on an inbound magnetic track 232° . select the available entry procedure.
Either "off set" or "parallel". |
|
7
What is the outbound timing in a holding pattern up to fl 140?
1 minute |
|
8
Unless otherwise published or instructed by atc, all turns after initial entry into the holding pattern shall be made into which direction?
To the right. |
|
9
Entering a holding pattern at fl 110 with a jet aircraft, which will be the maximum speed ?
230 kt ias. |
|
10
In a holding pattern all turns are to be made at a :
Rate of 3° per second or at a bank angle of 25° , which ever requires the lesser bank. |
|
11
What will be your action if you can not comply with a standard holding pattern?
Inform the atc immediately and request a revised clearance. |
|
12
What is the outbound timing in a holding pattern above fl 140?
1 minute 30 seconds. |